Article ID : 00077237 / Last Modified : 31/08/2020

I cannot make a Wi-Fi connection between the Action Cam and the mobile device

    IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.

    Check the following steps.

    NOTE: To connect the Action Cam and smartphone(*) via Wi-Fi, the dedicated application, Imaging Edge Mobile (PlayMemories Mobile successor), is needed. 
    Android smartphone / tablet or iPhone / iPad

    1. Use the latest version of the application and the Action Cam’s system software.
      The latest version of the application can be found here. Imaging Edge Mobile Download website
      For details of the Action Cam's system software, refer to the support page of each product.
    2. Turn off your Action Cam and your smartphone.
       
    3. Remove the battery pack and the memory card from the Action Cam, and then reinsert them.
      NOTE:
      • If a recordable memory card is not correctly inserted into the Action Cam, the Action Cam may not be able to connect via Wi-Fi.
      • Make sure to insert the memory card correctly after confirming the direction and front/back of the memory card.
         
    4. Turn on your Action Cam and your smartphone.
       
    5. Check that Wi-Fi is enabled on each LCD screen of the Action Cam and smartphone. When Wi-Fi is enabled, a Wi-Fi mark is displayed on the screen.
      NOTE: When an airplane mark is displayed on the LCD screen, the airplane mode is enabled. In this case, you cannot make a Wi-Fi connection. Disable the airplane mode. For details on operation method, refer to the manual supplied with the product.
       
    6. Start Imaging Edge Mobile installed on the smartphone. For how to setup and operate, refer to the following: 
      Imaging Edge Mobile > How to use
      NOTE: If you are using an iPhone, tap Settings to turn on Wi-Fi. Then, select the SSID of the Action Cam to connect with the Action Cam via Wi-Fi and activate Imaging Edge Mobile.
       
    7. Action Cam settings differ between Single connection (connect your smartphone and a single Action Cam) and Multi connection (connect your smartphone and multiple Action Cam).
      Follow the procedure below and check that your Action Cam has a suitable setting.
      • Single connection

        • FDR-X3000 / FDR-X1000V / HDR-AS300/ HDR-AS200V / HDR-AS100V / HDR-AS50 / HDR-AS30V / HDR-AS20
          Wi-Fi is set to ON in the camera SETUP menu.
        • HDR-AZ1
          If a Wi-Fi mark is not displayed on the display panel of the camera or the bar is displayed above the mark, press the Wi-Fi button until only the Wi-Fi mark is displayed.
      • Multi connection
        NOTE: FDR-X3000 / FDR-X1000V / HDR-AS300 / HDR-AS200V / HDR-AS50 only
        For more details, see the following:  Multi Camera Control(Action Cam)
         
    8. Reset the camera setting and check if the symptom improves. For details on operation method, refer to the manual supplied with the product.