About This Download

Previous Benefits and Improvements

File Info

• Name: BODYDATA.DAT
• Version: 3.00
• Size: 1 053 010 392 bytes
• Release Date: 03-02-2026

Preparation

Other Hardware

• HDMI cable
• HDMI monitor

Note: Connect the external monitor to your camera using the HDMI cable and check the screen to ensure the update is running smoothly.

Check the System Software Version

Follow the instructions below to check the system software version:

1. Select Menu → Setup → Setup Option → Version → Body.
2. The system software version will be displayed.
   

Notes:

• If the system software version is Ver. 3.00, the update is not required.
• If the Date/Time setting screen appears when you turn on your camera, be sure to set the date and/or time to the correct values.

Saving the System Software Data to a Memory Card

1. Click the Download button.
2. After reading the disclaimer, click Download.
3. Save the file to your computer.
4. Insert the formatted memory card into the computer.
5. Save the BODYDATA.DAT file in the root directory of the memory card. Do not change the file name.

Notes:

• Please format the memory card in advance using this camera.
• Before formatting, copy the data to a computer or other device.
  • Once you format the memory card, all the data recorded on it will be deleted and cannot be restored.
• Please refer to the instruction manual of the camera for compatible memory cards.

Updating the System Software Version

Important Notice

• Connect the external monitor to your camera using the HDMI cable and check the screen to ensure the update is running smoothly.
• Do not remove the power cable during the update as the sudden loss of power may render the camera inoperable.
• It may not be possible to update if the camera temperature is high. Please wait to update until after the temperature drops.

Step 1: Update the System Software

1. Insert the memory card that contains the saved system software data into slot of the camera.
2. Select Menu → Setup → Setup Option → Version → Body.
3. Select Software Update.
4. Select Execute on the system software update confirmation screen. The software version update will start.
   
   On-screen message:
   • Update? X.XX → Y.YY
     • X.XX: Current version number
     • Y.YY: Newest version number
   Notes:
   • Do not unplug the power cable or memory card during the update.
   • After confirming the details, you may click Execute.
   • Please scroll down the screen as necessary to view the full text.
5. When the system software update starts, you will see no HDMI signal output and the access lamp will flash 1 time → 3 times → 5 times depending on the progress of the update. The update will take approximately 6 minutes to complete.
   
   Notes:
   • If the system software data copy is incorrect, the message “The target model for the update file is incorrect” will appear on the monitor.
   • If the access lamp repeats 5 long blinks (0.5-second cycle) and 6 short blinks (0.25-second cycle), or 7 long blinks (0.5-second cycle) and 7 short blinks (0.25-second cycle), the system software may have been incorrectly copied to the memory card.
     • In this case, remove the power cable and memory card from the camera, prepare another memory card, and then start over from the Saving the System Software Data to a Memory Card section of this article.
6. When the update is complete, the camera will automatically restart. After restarting, press OK on the “Body update complete” screen.
   

Step 2: Confirm the System Software Version of Your Camera

1. Select Menu → Setup → Setup Option → Version → Body.
2. The system software version will be displayed.
   The update was successful if the screen shows Ver. 3.00.